Quantcast
Channel: Motorcycles Repair Manual Download and Reviews » hardware installation
Viewing all articles
Browse latest Browse all 4

HARLEY DAVIDSON VRSCD SADDLEBAG MOUNTING KIT INSTALLATION MANUAL

0
0

download
INSTALLATION Prepare Bike for Hardware Installation 1. Use a suitable lift to support the motorcycle under the frame until the rear suspension is fully extended. NOTE To remove the tether from the hole in the frame, reach under the frame tube to align the metal tee (located on the end of the seat tether) with the tether cable. 2. See Figure 1. Unlatch and open seat. Remove tether (4) by sliding small clip (3) sideways through hole in frame. NOTE To remove the tubular plastic seat-hinge sleeve from the hinge, turn the sleeve to reveal the slotted length. Push on the slot with your finger to pop the sleeve off the hinge pins. Closing the seat slightly allows the sleeve to fall from the hinge-side of the seat, so be prepared to catch the sleeve. 3. Remove plastic sleeve (2) from hinge pins (1) and slide pins toward rear of bike. Remove seat. 2 1 4 3 is 00449 1. Hinge 2. Sleeve 3. Clip 4. Remove tether from frame Figure 1. Remove Seat 3 1 2 is 00450 1. Grabstrap 2. Passenger Pillion 3. Screw and Washer Figure 2. Remove Passenger Pillion 4. See Figure 2. Remove screw and washer (3) securing passenger pillion to frame. Slide pillion under grabstrap (1) and forward to disengage from tongue to remove. Save pillion mounting screw and washer for later use


Viewing all articles
Browse latest Browse all 4

Latest Images

Trending Articles





Latest Images